|
HILLS
|
Bob Yarborough
- Stagecoach - Monteagle, TN
|
Dan Moses - Stagecoach - Monteagle, TN
|
Hills are
one of the most dangerous obstacles in four wheeling. Hills
have claimed many vehicles over the years. Most people will
attempt to climb small, steep inclines, but not many go for
the super long and steep hills. Those that try the long hill
climbs and are successful, know the limitations of their vehicles
and are experienced drivers. If you feel uncomfortable about
climbing up a hill, don't try it.
-
When driving
up or down a hill, always try to go straight. If you start going
at an angle, it might cause the vehicle to start the rolling
process.
- Keep your
wheels on the ground at all times. As stated earlier, the more
your vehicle bounces, the greater chance it has to break parts,
important parts.
- When going
up a hill, the best type of soil condition is damp soil. It
offers you a lot better traction than muddy, dry, or loose.
Muddy, dry and loose cause the vehicle's tires to spin out and
loose traction.
- When approaching
the top of a hill, make sure you know what is on the other side
and ease up on the gas. You don't want to go flying over the
hill and end up in some crazy position.
- You should
apply the most power to your vehicle when you start going up
the hill. This gives you more momentum for the ride up.
- When you
are going down a hill, keep your foot near the brake pedal.
If you need to use your brakes, use them lightly, too hard will
cause your wheels to lock up and you could start sliding. If
you start to slide, remember the rules of snow and ice, turn
in the direction that you are sliding.
- Always
use low gearing when driving down a steep hill.
|
|
Mud
|
Rob Matzell
- Sarari Triathlon
|
Dave Cagle - Coppenger Cove - Monteagle, TN
|
- ALWAYS
know what kind of mud you are going through. Be sure that you
know how deep the mud hole is and if there are and rocks or
logs at the bottom (tire poppers). On some trail rides, vehicles
have gone into a mud hole and come out with a busted tire because
they did not know about the rocks at the bottom.
- While going
through a mud hole, turn your steering wheel back and forth
so the tires can find traction.
- If you
happen to get stuck, try backing up and going forward again.
If this doesn't help, try backing out of the hole. Spinning
your tires will only make the hole deeper and you will find
yourself in deeper mud than when you entered the hole.
- A word
to the wise: If you see tracks going into a mud hole and don't
see them on the other side, think again.
|
|
Sand
|
Michael Wolf
- Safari Triathlon
|
Brandon Russell - Safari Triathlon
|
- When driving
on sandy trails or open desert, make sure that you have good
steady speed.
- Use four-high
when driving in the sand.
- It is a
good idea to air down your tires as well. Use should usually
have them between 8 and 10 lbs of pressure.
- If you
happen to get stuck, there are a few things you might try. The
first one is wetting the sand around you to give you more traction.
You might also want to place your floor mats under the tires
for traction. You can also try digging out around the tires
and placing an object under your tires. If you don't have either
one of the things, try using a Pull-Pal or other winching device.
If all else fails, radio or call for help.
|
|
Ruts
|
Mark Lloyd
- Tellico, NC
|
Ruts
can very tricky on the trails. Some trail conditions make it where
you have to drive down the side of a rut, straddle the rut and
then end up in it, or even one that you cannot get out of.
-
When
you see that the trail ahead of you is a big rut and you're
sure that you will end up in it, try and straddle it. If it
starts to get wider, ease down into it. Keep your vehicle
level and try to ride the sides of the rut with the sides
of your tires or sidewalls.
- Make sure
you have a spotter to guide you through the rut. Remember, even
if you know the trail like the back of your hand, trails are
always changing and eroding.
- Keep your
vehicle centered and level as possible while in a rut when possible.
|

©2000
Tennessee Off-Road
|